How to assemble INTERNAL Blum Tandembox deep drawer boxes

ENQUIRIES 01289 466101

Need help measuring? Text any photos to 07368126240

quality drawers made for any space

HOW TO ASSEMBLE - INTERNAL BLUM TANDEMBOX ANTARO - Deep

This page shows the quickest and easiest way to assemble your drawer box.
A video of each procedure is also available on the product page.

		Tools and materials required. Cordless drill driver or equivalent Phillips screwdriver Set square or straight edge Tape measure Pencil Supports, or a box that is taller than the drawer sides

		Complete internal drawer kit Please Note - Back Brackets are now sent loose to prevent damage in transit The section below shows how to attach the back bracket to the drawer side. There will be 1 x left hand bracket and 1 x right hand bracket for each drawer

		Line up the back bracket as shown in the image and push firmly down. You will hear a click as the bracket locks into place. The brackets are made left and right sided, and can only go on one way on the correct drawer side.

		Lay the drawer base on top of the cardboard box or packer Put the drawer side in position and line up the end with the front of the base as shown Hold in position and put the screws in to secure the drawer side

		Repeat for the other side

		Turn the box over and slide the back panel into position Attach the back panel with the 10 x 15mm screws supplied

		Click the two gallery rails into position from the top down as shown

		Line up the fixing brackets on the drawer front with the drawer sides Click the drawer front into place Screw the orange barrels into position

		Finally, slide the cover section to enclose the fixings

		Your drawer is now assembled You are now ready to mark out and attach the drawer runners