How to assemble Blum Tandembox shallow drawer boxes

ENQUIRIES 01289 466101

Need help measuring? Text any photos to 07368126240

quality drawers made for any space

HOW TO ASSEMBLE - BLUM TANDEMBOX ANTARO - Shallow

This page shows the quickest and easiest way to assemble your drawer box.
A video of each procedure is also available on the product page.

		Tools and materials required. Cordless drill driver or equivalent Phillips screwdriver Set square or straight edge Tape measure Pencil Supports, or a box that is taller than the drawer sides

		Complete drawer kit Please Note - Back Brackets are now sent loose to prevent damage in transit The section below shows how to attach the back bracket to the drawer side. There will be 1 x left hand bracket and 1 x right hand bracket for each drawer

		Line up the back bracket as shown in the image and push firmly down. You will hear a click as the bracket locks into place. The brackets are made left and right sided, and can only go on one way on the correct drawer side.

		Lay the drawer base on top of the supports Position the drawer side as shown tight against the base panel.

		Ensure that the ends of the drawer side and base line up as shown. Attach the drawer side to the base with the screws supplied

		Repeat for the other side

		Turn the box over and slide the back panel into position Attach the back panel with the 4 x 15mm screws supplied You are now ready to mark out and attach the drawer runners