|
HOW TO ASSEMBLE - INTERNAL METABOX - Deep
|
|
|
|
|
This page shows the quickest and easiest way to assemble your drawer box.
A video of each procedure is also available on the product page.
|
| | Tools and materials required.
- Cordless drill driver or equivalent
- Philips screwdriver
- Set square or straight edge
- Tape measure
- Pencil
- Supports, or a box that is taller than the drawer sides
|
| | |
| | - Complete internal drawer kit
|
| | |
| | - First attach sides onto front by slotting each side into the plastic bracket n the drawer front
- Tighten the screw on each bracket
|
| | |
| | - Place the base of the drawer box on top of the cardboard box or packer
- Present the completed front and sides to the base as shown
|
| | |
| | - Pull the base tight against the front ensuring there is no gap
|
| | |
| | - Attach the base using the 15mm screws supplied
|
| | |
| | - Turn the box over and slide the back panel into position
- Attach the back panel with the 8 x 15mm screws supplied
- You are now ready to mark out and attach the drawer runners
|
| | |
| | |
|
|
|
